Motogadget M-Button

£43.99 inc. VAT

Motogadget

Motogadget M-Button

Reduce cable clutter for a perfect custom build. Simplifies the wiring harness and works with the M-Unit

SKU: MG-MB1 Categories: , , Brand:

Description

Motogadget M-Button

The M-Button is a big help – in combination with the new M-Unit V.2 – in reducing ‘cable clutter’ and simplifying wiring harnesses. A must-have for getting clean bars!

The M-Button is equipped with connections for
– turn signal, left side
– turn signal, right side
– headlight (low beam and high beam)
– E-starter
– horn
– brake light switch, front brake

M-Button – dimensions
Diameter: 12 mm
Length: 25 mm
Cable length: approx. 60 cm
Connecting cable to M-Unit: approx. 200 cm
Weight: approx. 30 g

Attention: The only intended use of the M-Button is in combination with M-Unit V.2.

Integrated into the handlebar tube – or any other adequate location – this tiny cylinder will electrically connect all handlebar instruments, switches and buttons.
Using state-of-the-art bus technology, the M-Button digitally processes signals and transmits them to the M-Unit V.2 over a thin cable.
The electrical consumers will then be switched inside the M-Unit.
All control wires are moved into the handlebar. This saves space, weight, labour and time. A ‘must have’ for custom bikes with clean-look handlebars.

In simple facts:
a) normally, the operating current (e.g. headlight or turn signals) is transmitted directly via the wiring of the handlebar switches. Due to the high currents, cables with large cross-sections have to be routed from the fuse box to the switch and back to the electrical consumer.
The result: big cable bundles. Definitely, a ‘no go’ for custom bikes with restricted space or a concealed electrical system.

b) using the M-Unit without the M-Button, just a thin cable for each switch- or button-controlled feature has to be routed to the M-Unit. These cables only carry minute control currents. All high loads and currents are switched directly at the M-Unit and transmitted directly to the electrical consumers. This already leads to a significant reduction and simplification of the wiring harness. Here you can see the example of a circuit diagram.

c) using the M-Unit V.2 in combination with the tiny M-Button, you will once again reduce the amount of cables that have to be routed! All switches/buttons on the handlebar are connected at the shortest distance possible and concealed inside the handlebar. Consequently, you will have to route only ONE thin cable from the M-Button to the M-Unit. All loads and currents will be switched directly at the M-Unit V.2 (see explanations above). A layout reduced to the max! Here you can see the example of a circuit diagram with use of M-Button.

The M-Button is completely moulded in, making it water-tight and resistant to vibrations.

 

Reviews

There are no reviews yet.

Be the first to review “Motogadget M-Button”

Your email address will not be published. Required fields are marked *

Pin It on Pinterest

Share This